EasyManua.ls Logo

Branson 8050 - Engine Oil and Filter Maintenance

Branson 8050
163 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
• • •
123
1. ENGINE OIL
CHECKING OIL
Pull out the dipstick, clean the tip of dipstick, put it back
into the engine, and pull it out again to see if the oil level
is between the upper and lower limit. If the oil level is
below the lower limit, add oil.
[Precaution]
Check the oil lever before the engine is started or after
the engine is cooled down.
CHANGING OIL
Drain the oil by removing the plug under the engine. Put
new oil through the engine oil ller hole. Change the oil
periodically, and select the right type of oil depending on
the temperature and usage.
Drain the oil when oil is warm but be careful.
If oil is hot, there is a risk of getting burnt.
CAUTION
PERIODIC MAINTENANCE & ADJUSTMENT
PERIODIC MAINTENANCE & ADJUSTMENT
8050 OPERATORS MANUAL (122011).indd 123 1/10/2012 9:36:52 PM

Table of Contents

Related product manuals