Branson F36r - EGTS Sensor (Exhaust Gas Temperature Sensor)

2
-
22
42hW-201601
CHAPTER 2 ENGINE 3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
DIAGNOSTICS
The following sensor diagnostics are when the
sensor is properly connected with a 5kohm pull-up
load to Vcc.
FAULT PIN OUTPUT
Open 1 > 96%Vcc
Open 2 > 96%Vcc
Open 3 > 96%Vcc
Short 1-2 < 4%Vcc
Short 1-3 > 96%Vcc
Short 2-3 < 4%Vcc
PART CHECK

DPS
5.1Kohm
C1
J1
J4
123
1
2
3
5V
Logger
K25W238A
1) SCANNER
1] (DIAGNOSTIC) - 4] Engine - 1] DPF Logger -
1] Self check - 8] Differential pressure voltage -
9] Differential pressure
2) Check the voltage 0.5± 0.2V under atmosphere
(Voltage of atmospheric pressure = 5V*10%)
3) How to check:
1. Turn off ignition switch.
2. Separate pressure sensor from connector.
3. Separate hose from pressure sensor.
4. Loosen bolts and separate pressure sensor
from car
4) DPS sensor installation torque: 1.0 ~ 1.2 kgf•m
4.4.2 EGTS SENSOR (EXHAUST GAS
TEMPERATURE SENSOR)
INTRODUCTION
Check the temperature of the exhaust gas from
DPF and data logger records the temperature of the
exhaust gas in Logger.
CIRCUIT
&
[

6(16
B
*1'
[

5
5

9$ 
5T 
&UIL
5   Nവ 
&   Q)
5   Nവ 
&UIL   Q)

K25W239A
8S 9
5S
&XOHDGV
&RQQHFWRU
VLJQDOJUH\ VHQVRU
76
JURXQGZKLWH
82 I7
K25W240A
RTD circuit to MCU
Voltages
- Power supply: Up = +5V
± 0.1%
- Output voltage: UO = See table
Resistances
- Pull up resistance: Rp = 1000
Ω ± 0.1%
- Lead resistance: R1 = 005 Ω (Ml-cable + Cu-leads)
- TS-200 0°C: RO = 200
- Total TS-200 resistance: Rs =
See table
•
•