Branson F36r - Page 71

2
-
25
42hW-201601
CHAPTER 2 ENGINE3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
2
DPF LAMP ON/OFF
If IGNITION KEY ON: Lamp ON for 1 sec•
DANGER LEVEL CONDITION LAMP DISPLAY
EMERGENCY
1.
△P > setting values(Pressure, time) It means DPF is clogged with Particular.
2. EGTS > setting value(Temp. time) It means that DPF almost melt.
Continuous
CAUTION Sensor malfunction Every 0.5sec.
CHECK
Working time > setting value(working time)
(*possible erasing lamp with scanner)
Every 2.0sec.
*) Setting1: emergency differential pressure setting: only super-user can set using scanner
SCANNER – 1] DIAGNOSTIC - 4] Engine - 1] DPF Logger - 2] Change setting - 1] DPS Warning Pressure –
F1(Increase) or F5(Decrease)
*) Setting2: emergency pressure time setting: only super-user can set using scanner
SCANNER – 1] DIAGNOSTIC - 4] Engine - 1] DPF Logger - 2] Change setting - 2] DPS Warning Time –
F1(Increase) or F5(Decrease)
*) Setting3: emergency exhaust temperature setting: only super-user can set using scanner
SCANNER – 1] DIAGNOSTIC - 4] Engine - 1] DPF Logger - 2] Change setting - 3] EGTS Warning
Temperature- F1(Increase) or F5(Decrease)
*) Setting4: emergency temperature time setting: only super-user can set using scanner
SCANNER – 1] DIAGNOSTIC - 4] Engine - 1] DPF Logger - 2] Change setting - 4] EGTS Warning Time –
F1(Increase) or F5(Decrease)
*) Setting5: DPF Cleaning Count :
SCANNER – 1] DIAGNOSTIC - 4] Engine - 1] DPF Logger - 2] Change setting - 5] Reset DPF Cleaning Count
– F1(Increase)