Breas NIPPY ST+ - Using Supplementary Oxygen

32
Using Supplementary Oxygen with the NIPPY ST+
If required, supplementary oxygen may be entrained into the breathing circuit up to a
maximum of 15 L/minute.
When adding oxygen, fit an entrainment port at the mask / tracheotomy end of the
circuit.
Nippy
Outlet
Port
Filter
Oxygen port
Patient
Outlet
Port
Switch on the NIPPY before the oxygen.
When treatment is complete, switch off and disconnect the oxygen supply, Switch
off the NIPPY and disconnect the breathing circuit. Store the breathing circuit in a
clean bag or other suitable container.
DO NOT leave the oxygen connected when not in use. This can cause a build-up of
oxygen in, or around the machine
DO NOT block the end of the breathing circuit with oxygen connected.
DO NOT expose oxygen to naked flames.
DO NOT smoke in the vicinity
DO NOT use a gas cooker in the vicinity
DO NOT use a gas, oil or solid fuel heater in the vicinity
Precaution: always follow user instructions when entraining Oxygen.