Brent 1082/882 — Set Up
2-6
Basic Set Up (continued)
Wheel/Tire Set Up
Tire Pressure
Tire pressure must be verifi ed before fi rst use and adjusted as necessary. Refer to maintenance
section of this manual for information on tire pressure.
Wheel Nuts
• IMPROPERLY TORQUED WHEEL NUTS/BOLTS CAN CAUSE A LOSS OF IMPLEMENT
CONTROL AND MACHINE DAMAGE. WHEEL NUTS/BOLTS MUST BE CHECKED REGU-
LARLY. SEE TORQUE PAGE IN THE “MAINTENANCE” SECTION FOR PROPER WHEEL
NUT/BOLT SPECIFICATIONS. WARRANTY DOES NOT COVER FAILURES CAUSED BY
IMPROPERLY TORQUED WHEEL NUTS/BOLTS.
• Installing wheels without the proper inset could result in hub or spindle failure. This will cause
substantial damage to cart.
Dual Wheel Installation
Align the dual wheels on the one side of the cart. Place the guide pin in the guide hole. Then,
using the guide pin, seat the outer reinforcing ring into position. Secure the wheel and reinforcing
ring with the lock washers and bolts provided. Refer to the “MAINTENANCE” section for proper
torque requirements.
(November 2014)
To Next Page
