Brent 1082/882 — Set Up
2-7(July 2015)
Basic Set Up (continued)
Optional Adjustable Axle
• FALLING OBJECTS CAN CAUSE SERIOUS INJURY OR DEATH. DO NOT WORK UNDER
THE MACHINE AT ANY TIME WHILE BEING HOISTED. BE SURE ALL LIFTING DEVICES
AND SUPPORTS ARE RATED FOR THE LOADS BEING HOISTED. THESE ASSEMBLY
INSTRUCTIONS WILL REQUIRE SAFE LIFTING DEVICES UP TO 16,000 LBS. SPECIFIC
LOAD RATINGS FOR INDIVIDUAL LOADS WILL BE GIVEN AT THE APPROPRIATE TIME
IN THE INSTRUCTIONS.
• TIPPING OR MOVEMENT OF THE MACHINE CAN CAUSE SERIOUS INJURY OR DEATH.
BE SURE MACHINE IS SECURELY BLOCKED.
1. Hitch cart to tractor. Park the empty unit on a fi rm, level
surface. Set the tractor’s parking brake, shut-off en-
gine and remove the ignition key.
2. Using a safe lifting device rated for a minimum of 8 tons and supports rated at 4 tons minimum, raise
the cart and place supports under the axle near the axle clamps.
3. Loosen axle extension clamp and axle gauge bolts. Do not remove.
4. Slide extensions to desired tire gauge spacing. Axle extensions should be extended equally.
5. Tighten axle gauge bolts followed by axle clamp bolts.
6. Remove supports and lower cart to ground.
NOTE: If tires are positioned at a wider tread width, make sure lights are also moved out
to within 16” of the outside of tires. Refer to page 2-5 for details.
To Next Page
