Brent 1082/882 — Maintenance
4-9
Auger System (continued)
Auger Flow Door Cylinder Replacement
• TO PREVENT PERSONAL INJURY OR DEATH ALWAYS ENSURE THAT THERE ARE
PEOPLE WHO REMAIN OUTSIDE THE CART TO ASSIST THE PERSON WORKING INSIDE,
AND THAT ALL SAFE WORKPLACE PRACTICES ARE FOLLOWED. THERE IS RESTRICTED
MOBILITY AND LIMITED EXIT PATHS WHEN WORKING INSIDE THE IMPLEMENT.
• NEVER ENTER CART WITH AUGER OR TRACTOR RUNNING. SERIOUS OR FATAL IN-
JURY CAN OCCUR DUE TO ENTANGLEMENT WITH ROTATING COMPONENTS. ALWAYS
STOP ENGINE AND REMOVE KEY BEFORE ENTERING CART.
• EYE PROTECTION AND OTHER APPROPRIATE PERSONAL PROTECTIVE EQUIPMENT
MUST BE WORN WHILE SERVICING IMPLEMENT.
• KEEP HANDS CLEAR OF PINCH POINT AREAS.
• RELIEVE HYDRAULIC SYSTEM OF ALL PRESSURE BEFORE ADJUSTING OR SERVIC-
ING. SEE TRACTOR OPERATOR'S MANUAL FOR PROPER PROCEDURES.
• HIGH-PRESSURE FLUIDS CAN PENETRATE THE SKIN AND CAUSE
SERIOUS INJURY OR DEATH. SEEK MEDICAL TREATMENT IMMEDI-
ATELY IF INJURED BY HIGH-PRESSURE FLUIDS. USE CARDBOARD
OR WOOD TO DETECT LEAKS IN THE HYDRAULIC SYSTEM.
• HYDRAULIC SYSTEM MUST BE PURGED OF AIR BEFORE OPERATING TO PREVENT
SERIOUS INJURY OR DEATH.
1. Park the empty grain cart on a fi rm, level surface and extend auger. Block the tires/tracks on the
machine to keep it from moving. Unfold upper auger to make the fl ow door cylinder easier to ac-
cess. If possible, close the fl ow door at least 8” from the fully open position. Relieve hydraulic pres-
sure, see tractor operator’s manual. Set the tractor’s parking brake, shut-off the engine, remove the
ignition key and disconnect the PTO shaft.
(July 2014)
To Next Page
Loading...
