When the “Front” or “Rear FOV” is set to 0° or 180° the
“Blending Width” option has no effect since there is no
overlapping areas, e.g. 100% of the front field of view is
using the front camera.
When the “Front” or “Rear FOV” is set to any a value
other than 0° or 180° the amount of overlap between
the side and front/rear cameras is determined by the
“Blend Width”.
The Line 1 option creates a “hard” join between the side and front/rear camera images,
there is no gradual or configurable blend for this Mask Type, the adjacent images are
stitched together i.e. there is no blending, overlapping or gradual fade.
This Mask Type also comes with a customisable line (line thickness and colour can be
changed) that indicates where the camera images join.
As with Blending FOV, the user can adjust the Front and Rear FOV angle to show more
or less of the front and rear cameras.
Note: this view may appear the “cleanest” blend when the vehicle is stationary
however objects moving between the line area’s may appear to disappear.
To Next Page
