BrightDrop Zevo 600 Owner Manual (GMNA-Localizing-U.S./Canada-
16569273) - 2023 - CRC - 11/3/22
10 Keys, Doors, and Windows
Temporary Disable of Passive Locking
Temporarily disable passive locking by
pressing and holding
K on the interior door
switch with a door open for at least
four seconds, or until three chimes are
heard. Passive locking will then remain
disabled until
Q on the interior door is
pressed, or until the vehicle is turned on.
Remote Left In Vehicle Alert
When the vehicle is turned off and a remote
key is left in the vehicle, the horn will chirp
three times after all doors are closed. To
view available settings from the
infotainment screen, touch Settings >
Vehicle > Remote Lock, Unlock, Start.
Remote Removed From Vehicle Alert
If the vehicle is on with a door open, and
then all doors are closed, the vehicle will
check for remote keys inside. If a remote
key is not detected, the Driver Information
Center (DIC) will display NO KEY FOUND and
the horn will chirp three times. This occurs
only once each time the vehicle is driven. To
view available settings from the
infotainment screen, touch Settings >
Vehicle > Remote Lock, Unlock, Start.
Key Access
To access a vehicle with a weak remote key
battery, see Door Locks 0 13.
Programming Remote Keys to the
Vehicle
Only remote keys programmed to the
vehicle will work. If a remote key is lost or
stolen, a replacement can be purchased and
programmed through your dealer. The
vehicle can be reprogrammed so that lost or
stolen remote keys no longer work. Each
vehicle can have up to eight remote keys
programmed to it.
Programming with a Recognized
Remote Key
A new remote key can be programmed to
the vehicle when there are two recognized
remote keys. To program, the vehicle must
be on and the recognized and new remote
keys must be with you.
1. Place the recognized remote keys on the
passenger seat.
2. Navigate to, and select, "Remote Key
Relearn" through the Driver Information
Center (DIC).
The DIC displays READY FOR REMOTE.
3. Place the new remote key in the storage
compartment above and behind the
infotainment display.
4. Press POWER
O. When the remote key is
learned the DIC display will show that it
is ready to program the next
remote key.
5. Remove the remote key from the IP
storage tray and press
Q or K on the
remote key.
To program additional remote keys, repeat
Steps 4–5.
To Next Page
