brim Trio Multibrew System - Using the K-Cup Capsule Adaptor

24
Using the K-Cup® Capsule Adaptor
• Each K-Cup® is loaded with the perfect measure of
coffee, tea or even hot chocolate.
• Capsules are an effortless and fool-proof way to brew a
single hot cup, mug, or commuter travel mug serving.
• There are now over 400 K-Cup® varieties to choose from!
• Many generic coffee capsules (pods) can be used in the
BRIM Trio Multibrew System.
IMPORTANT: Foroptimalavor,lteredwaterispreferred.
WARNING: Before brewing, it is recommended the water
tankbelledatleasttothelowest“
6 oz. step. To avoid damage, never operate your Coffee
Maker when the single serve water tank is empty.
1. Use the side tab to lift the single serve water tank lid. (See Figure 8.)
2. Using the desired cup, mug, or tumbler as your measure, add water to the water tank. The
water tank has an easily visible, 3-stepped water level indicator: 6 oz., 10 oz., and 15 oz.
WARNING:NEVERexceedthe15oz.MAXllstep.
NOTE: The Coffee Maker will not measure water quantity. Any amount of water in the single
serve water tank will brew. ALWAYS check to make sure the proper capacity cup or mug is
properly centered on the assembled drip tray.
3. Lower the lid.
4. Center the cup on the drip tray, under the single serve nozzle.
5. Pull the adaptor compartment’s front tab up to unlock and lift the lid.
6. Add the capsule of your choice to the adaptor. Press down on the capsule to pierce the
bottom.Makesurethecapsuleisushwiththeadaptor.
7. With the handle facing front, place the capsule adaptor into the adaptor compartment.
Slide the adaptor handle in to the grooves at the front of the Coffee Maker. (See Figure 8.)
Figure 8
SO-315939_50017 BRIM Trio MultiBrew IM R2.indd 24 2019-03-07 1:46 PM