11
Operation
IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During transit, dust and
odors can accumulate in the tank and lines. Dispense and dispose at least one quart of water prior
to drinking any water.
Turn the Dispenser On/O
IMPORTANT: Before you activate the hot and cold switches, ensure water has filled the tanks inside the
dispenser in order to prevent dry heating.
1. Plug in the dispenser.
2. Run water through the cold and hot water taps until water begins to dispense.
3. To power on the cooling system, flip the cooling switch on the back of the dispenser to the On position. The cold
water button on the front of the dispenser illuminates in blue indicating the dispenser is cooling water. The light
changes to white when the cooling process is complete.
4. To power on the heating system, flip the heating switch on the back of the dispenser to the On position. The hot
water button on the front of the dispenser illuminates in red indicating that the dispenser is heating water. The
light changes to white when the heating process is complete.
Set the Time
1. Press and hold the up and down arrow buttons for 3 seconds until the clock display begins to blink.
2. Press the cold water button to set the minute and the hot water button to set the hour. Use the up and down
arrow buttons to scroll until the correct minute/hour is displayed.
3. Press the lock button until the selected time stops blinking. The time is now set.
Set the Cold Water Temperature Level
You can select from 3 dierent cold water dispensing temperature levels: C1 (cold), C2 (colder), and C3 (coldest).
Temperature Level Dispensing Temperature Range
C1 49°F to 55°F
C2 43°F to 49°F
C3 37°F to 43°F
NOTE: The default temperature dispensing level for cold water is C3 (coldest).
To change the cold water temperature dispensing level, please do the following:
1. Simultaneously press and hold the lock and cold water buttons for 3 seconds. The cold water button and LED display
showing current cold water temperature level begin to flash.
2. Press the up or down arrow to scroll through the 3 options. They will be displayed as C1, C2, and C3. After you have
reached the desired temperature level, quickly press the lock button. The new level is now set. It takes approximately
2 hours for the cold water temperature range to adjust to the new level. During the adjustment process, the cold water
light will illuminate in blue. Once the new level has been reached, the light will change to white.
NOTE: Cold water temperature is measured inside cold reservoir tank. Due to many variables, including but not
limited to, ambient temperature, water receptacle size/temperature, internal travel from reservoir tank to
dispense point, etc., temperature range of water dispensed will vary from stated range.
To Next Page
Loading...
Need help?
General
