9
4. Flush the Filters
Follow this procedure each time you replace your filters.
IMPORTANT: Ensure water supply is o before you begin.
IMPORTANT: Flush ONLY the sediment, pre carbon, and post carbon filters. The reverse
osmosis (RO) filter should not be flushed.
A. Connect a filter (D) to the filter housing (C) by
twisting the filter (D) clockwise.
C
D
B. Connect the tip of the shut-o valve tube (B)
to the left side of the filter housing (C).
C. Connect the filter flushing tube (A) to the
right side of the filter housing (C) and lay the
open end of the filter flushing tube (A) over a
sink or receptacle to collect water.
A
C
B
D. Turn on valve at water source. Flush each
filter for a minimum of 5minutes. The
recommended rate is 1.5-3gallons of water
(about 10 minutes) oruntil the water is clear
in appearance.
E. Shut o the valve at the water source and
remove the filter housing from the tube (B).
B
To Next Page
Loading...
Need help?
General
