Important Safety Information
•
Please read these instructions thoroughly and retain for future use.
•
All products manufactured and supplied by Bristan are safe provided they are installed
correctly, used correctly and receive regular maintenance in accordance with these
instructions.
•
If you are in any doubt about your ability to install this shower valve safely you must
employ the services of an experienced qualified plumber.
•
This shower valve needs to be installed in accordance with, and meet the requirements of
the Water Supply (Water Fittings) Regulations 1999 and Scottish Byelaws 2004.
•
Warning: Do not operate the shower valve if you suspect it is frozen. Do not site the
shower valve where it might be subjected to freezing conditions.
•
Do not crush or kink the shower hose as this could damage the hose and cause leaks.
•
Remove all packaging and check the contents for damage before starting installation.
•
Warning: Before starting any installation please consider the following: before drilling
into walls, check that there are no hidden electrical wires, cables or water supply pipes.
This can be checked with the aid of an electronic detector.
•
If power tools are used do not forget to; - Wear eye protection
- Unplug equipment after use
•
Fitting Isolating valves to the inlet feeds is required for ease of maintenance.
•
Warning: Before installing the new shower valve it is essential that you thoroughly
flush through the pipework in order to remove any remaining swarf, solder, etc. Failure to
carry out this procedure could cause problems or damage to the workings of the shower
valve.
•
It is recommended that when installing the shower valve, full access is provided for
servicing purposes.
• This shower valve must not be modified in any way as this will invalidate the guarantee.
03
To Next Page
Loading...
