53-1004408-11 Installation Guide
Brocade
®
G610 Switch Hardware Installation Guide
There are four pairs of vertically aligned holes in the brackets. Each pair is labeled with a letter as are few single holes
along the length of the bracket. Each letter corresponds to a specific device's mounting holes. For the Brocade G610, use
the holes that are marked with the letter ‘A.’
NOTE
Example illustrations in the following procedures may show the screws that are inserted in holes that are
designated for devices other than the device that you are installing. Be sure to use holes that are designed for
installing your device.
53-1004408-11
34
To Next Page
Loading...
