Broadcom NetXtreme II SERIES - Page 150

Fibre Channel Over Ethernet: Broadcom NetXtreme II® Network Adapter User Guide
file:///C|/Users/Nalina_N_S/Documents/NetXtremeII/English/fcoe.htm[9/5/2014 3:45:12 PM]
6. For each interface to be enabled for FCoE boot, click Change Settings and ensure FCoE Enable and AUTO_VLAN are set to yes and DCB required is set to no.
7. For each interface to be enabled for FCoE boot, click on Create FCoE VLAN Interface. The VLAN interface creation dialog will launch. Click Yes to confirm. This will trigger
automatic FIP VLAN discovery. If successful, the VLAN will be displayed under FCoE VLAN Interface. If no VLAN is visible, check your connectivity and switch configuration.
8. Once complete with configuration of all interface, click OK to proceed.