Broadcom NetXtreme II SERIES User Manual

iSCSI Protocol: Broadcom NetXtreme II® Network Adapter User Guide
file:///C|/Users/Nalina_N_S/Documents/NetXtremeII/English/iscsi.htm[9/5/2014 3:45:06 PM]
32 Information Initiator received an asynchronous logout message. The Target name is given in the dump data.
33 Error Challenge size given by the target exceeds the maximum specified in iSCSI specification.
34 Information
A connection to the target was lost, but Initiator successfully reconnected to the target. Dump data
contains the target name.
35 Error Target CHAP secret is smaller than the minimum size (12 bytes) required by the specification.
36 Error
Initiator CHAP secret is smaller than the minimum size (12 bytes) required by the specification.
Dump data contains the given CHAP secret.
37 Error FIPS service could not be initialized. Persistent logons will not be processed.
38 Error Initiator requires CHAP for logon authentication, but target did not offer CHAP.
39 Error
Initiator sent a task management command to reset the target. The target name is given in the
dump data.
40 Error Target requires logon authentication via CHAP, but Initiator is not configured to perform CHAP.
41 Error Target did not send AuthMethod key during security negotiation phase.
42 Error
Target sent an invalid status sequence number for a connection. Dump data contains Expected Status
Sequence number followed by the given status sequence number.
43 Error Target failed to respond in time for a login request.
44 Error Target failed to respond in time for a logout request.
45 Error
Target failed to respond in time for a login request. This login request was for adding a new
connection to a session.
46 Error Target failed to respond in time for a SendTargets command.
47 Error Target failed to respond in time for a SCSI command sent through a WMI request.
48 Error Target failed to respond in time to a NOP request.
49 Error Target failed to respond in time to a Task Management request.
50 Error Target failed to respond in time to a Text Command sent to renegotiate iSCSI parameters.
51 Error
Target failed to respond in time to a logout request sent in response to an asynchronous message
from the target.
52 Error
Initiator Service failed to respond in time to a request to configure IPSec resources for an iSCSI
connection.
53 Error
Initiator Service failed to respond in time to a request to release IPSec resources allocated for an
iSCSI connection.
54 Error Initiator Service failed to respond in time to a request to encrypt or decrypt data.
55 Error Initiator failed to allocate resources to send data to target.
56 Error Initiator could not map an user virtual address to kernel virtual address resulting in I/O failure.
57 Error Initiator could not allocate required resources for processing a request resulting in I/O failure.
58 Error Initiator could not allocate a tag for processing a request resulting in I/O failure.
59 Error Target dropped the connection before the initiator could transition to Full Feature Phase.
60 Error
Target sent data in SCSI Response PDU instead of Data_IN PDU. Only Sense Data can be sent in
SCSI Response.
61 Error Target set DataPduInOrder to NO when initiator requested YES. Login will be failed.
62 Error Target set DataSequenceInOrder to NO when initiator requested YES. Login will be failed.
63 Error Cannot reset the target or LUN. Will attempt session recovery.
64 Information Attempt to bootstrap Windows using iSCSI NIC Boot (iBF).
65 Error Booting from iSCSI, but could not set any NIC in Paging Path.
66 Error Attempt to disable the Nagle Algorithm for iSCSI connection failed.
67 Information If Digest support selected for iSCSI Session, will use Processor support for Digest computation.
68 Error
After receiving an async logout from the target, attempt to relogin the session failed. Error status is
given in the dump data.
69 Error Attempt to recover an unexpected terminated session failed. Error status is given in the dump data.
70 Error
Error occurred when processing iSCSI logon request. The request was not retried. Error status is
given in the dump data.
71 Information
Initiator did not start a session recovery upon receiving the request. Dump data contains the error
status.

Broadcom NetXtreme II SERIES Specifications

General

Brand	Broadcom
Model	NetXtreme II SERIES
Category	Network Card
Language	English