Brocade FastIron GS and FastIron GS-STK Hardware Installation Guide 17
53-1001783-01
DRAFT: BROCADE CONFIDENTIAL
Chapter
2
Installing FastIron GS and FastIron GS-STK Devices
The procedures in this manual are intended for qualified service personnel.
Unpacking a system
This chapter describes how to physically install FastIron GS and FastIron GS-STK devices.
Information about configuring IP addresses and connecting network devices is in the chapter
“Connecting Network Devices and Checking Connectivity” on page 55.
FastIron GS and FastIron GS-STK devices ship with all of the items listed below. Please review the
list and verify the contents of your shipping container. If any items are missing, please contact the
place of purchase.
Package contents
The following items are shipped in with FGS and FGS-STK devices:
• Brocade FastIron GS or FastIron GS-STK device with one AC or DC power supply installed
• 115V AC US power cable (for AC-sourced devices - DC power supplies do not ship with a power
cable)
• Rack mount brackets and mounting screws
• One .5 meter CX4 stacking cable (FastIron GS-STK models only)
• CD-ROM with software images and user documentation (including this guide)
• EIA /TIA DB-9 serial cable (F or F)
• Warranty card and registration card
General requirements
To manage the system, you will need to connect a management station, such as a PC running a
terminal emulation application. Use the DB-9 serial cable for this connection.
Use the serial connection to perform basic configuration tasks, such as assigning an IP address
and network mask. This information is required to manage the system using the Web management
interface or IronView Network Manager, or using the CLI through Telnet.
To Next Page
Loading...
Need help?
General
