3-28
4. Push down hard on the foot brake pedal.
5. Select forward gear.
6. Move the park brake lever fractionally downward, just over center, slightly releasing it.
Hold park brake lever switch in the off position (located in the lever bracket).
7. Slowly release the foot brake pedal.
8. If the machine has not moved, use maximum engine speed. The machine should not
move.
9. Do not do this test for longer than 30 seconds.
10. Reduce engine speed to an idle.
11. Return the park brake lever to the fully ON position from its partially applied position.
Place transmission in neutral.
12. If the machine moved during the test, adjust the parking brake by checking the clearance
between the park brake pad and brake disc. Maximum clearance is .010” (0.254 mm) with
park brake lever in the OFF position, and repeat the test.
To Next Page
Loading...
