Brookeld Engineering Labs., Inc. Page 33 Manual No. M02-313E1209
1
Bit 2 is set in response to an R command (request for information) only.
2
If an input is received that is outside the allowable limits for a command, Bit
3 shall be set for the response to that command only. Once the response to
the command has been sent to the host, Bit 3 shall be cleared again.
3
This bit is set in response to a calibration command if an error occurred in the
respective operation
Table 2
Example:
1. The CAP 2000+ has been turned on with the proper cable inserted in the serial port placing
the unit in its external mode.
2. The host computer sends an I. The CAP 2000+ responds with an ICAPHI2201000000,
indicating a high temperature CAP 2000+ with Version 2.20 rmware, spring constant of
1.00, and a status byte of 0.
3. The host sends a T190. The CAP 2000+ begins controlling to 40.0°C and responds with
T100.
4. The host sends V1F4. The CAP 2000+ ramps to 500 rpm and responds with V02 indicating
the motor is running.
5. The host sends a T9C4. The request to control temperature to 250.0°C is illegal. The CAP
2000+ responds with T0A indicating a temperature request outside the limits of the instru-
ment.
6. The host sends an R. The CAP 2000+ responds with R002B1115950A25A83E80102 indi-
cating a viscosity reading of 11.025 Poise, a FSR reading of 55.25%, a shear rate of 6650
1/sec, a sensed temperature of 100.0°C, and a number one cone. Note that Bit 3 of the
status byte has been cleared. It is set only in response to the offending command (T9C4)
and is cleared as soon as the response is issued.
To Next Page
Loading...
Need help?
General
