Brother ADS-3100 - Page 28

Home > Paper Handling > Document Specifications > Unacceptable Documents > Document Areas That
Should Not Be Perforated
Document Areas That Should Not Be Perforated
Avoid perforating or punching holes in the shaded area shown in the illustration. Doing so will cause a scanning
error.
2
3
4
7
6
5
1
1. 1.77 in. (45 mm)
2. Top
3. Bottom
4. Center
5. Feed direction
6. Front side
7. Reference point
This condition applies when the document is set in the center of the Pick Up Roller.
Related Information
• Unacceptable Documents
24