Home > Paper Handling > Load Documents > Load a Plastic Card
Load a Plastic Card
1. Gently adjust the Paper Guides (1) to fit the width of your document.
2. Place the card, face down, top edge first in the ADF between the Paper Guides until you feel it touch the
inside of the machine.
• Load only one plastic card (with embossing) at a time.
• Certain types of plastic cards may be scratched when scanned.
• Rigid cards may not be fed correctly.
• If the surface of the card is dirty with grease marks (for example, fingerprints) or similar, wipe the dirt off
before scanning.
Related Information
• Load Documents
33
To Next Page
Loading...
