6. ASSEMBLY
BAS-311G, BAS-326G
72
<Inside X-LM guide installation>
1. With tension applied to the X-GT belt and the X-feed
motor assembly installed, use a push-pull tension
gauge to push the X feed bracket (1) from one edge
to the other in the X direction.
2. Tighten the eight bolts (2) at the place where the load
is 29 – 59 N (variation within 20 N).
<Right Y-LM guide installation>
1. With tension applied to the Y-GT belt and the Y-feed
motor L assembly installed, use a push-pull tension
gauge to push the X feed bracket (1) from one edge
to the other in the Y direction.
2. Tighten the two bolts (2) at the place where the load
is 39 – 78 N (variation within 20 N).
5185Q
5186Q
To Next Page
Loading...
