Brother BAS-311G - Adjusting the Needle Up Stop Position

6. ASSEMBLY
BAS-311G, BAS-326G
86
6-15. Thread wiper mechanism
1. Thread wiper unit
2. Bolts with washer [2 pcs]
3. Bolt (Remove)
4. Plain washer (Remove)
5. Removed plain washer
6. Removed bolt
7. STOP switch harness
8. Thread wiper solenoid harness
5153Q
A
djust the thread wipe
r
after installing. (Refer to “7-11. Adjusting the thread wiper”.)
A
lign the thread wiper shaft bracke
t
and the bottom of the arm and then
tighten the two bolts with washer.