Chapter 2 Preparation of Embroidery Machine
BES-962BC • BES-1262BC
27
Lift forks
The central seal
Embroidery machines should be installed only
by trained engineers.
Electric wiring should be laid by your distribu-
tor or electric experts.
The sewing machine weighs more than 720 kg.
The installation should be carried out by a lift
or a crane.
Do not connect the power source until installa-
tion is completed. Doing so may start the ma-
chine unintentionally through an accidental
activation of the START switch, resulting in
bodily injuries.
Install a machine in a place away from a high-
frequency welding machine or other machines
that may generate a strong electric noise. Fail-
ure to do so may cause the embroidery machine
to malfunction.
Be sure to connect the ground. If the ground
connection is not secure, you run a high risk of
receiving a serious electric shock, and problems
with correct operation may also occur.
Secure the machine with the adjustment bolts
on the sound floor so that it will not move .
2. Installation
* After installation is completed, get the power supply from a dedicated outlet.
* When connecting multiple machines, exercise care not to exceed the capacity of the outlet.
2-1 Transportation of Machine
When relocating the machine, push the steel frame.
Note) Never push the cover or carriage.
When using a fork lift
DANGER
Viewing the machine from the back, position their center at the central seal, insert the forks
under the legs and lift the machine.
To Next Page
Loading...
Need help?
General
