Setting Up the Machine
4
STEP1
1
1 Removing the protective
parts
1 Remove the protective tape and scanner glass
protection sheet.
Improper Setup
DO NOT connect the USB cable. Connecting
the USB cable is done during the software
installation process.
2 Attaching the control panel
cover
1 Attach the control panel cover to the machine.
3 Loading paper
You can load up to 100 sheets of 80 g/m
2
(20 lb) paper.
For details, see About paper in Chapter 1 of
the User’s Guide.
1 Pull the paper tray completely out of the
machine and remove the output paper tray.
2 Press and slide the paper guide (1) to fit the
paper width.
3 Pull out the paper support (1) and unfold the
paper support flap (2).
Note
Use the paper support flap for Letter, Legal and A4
paper.
11
1
2
To Next Page
Loading...
