Installing the Driver & Software
23
Macintosh
®
Network
Macintosh
®
For Network Interface Users (DCP-315CN only)
For Mac OS
®
X 10.2.4 or greater
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on page 4-9.
1 Disconnect the machine from the power
socket.
2 Turn on your Macintosh
®
.
3 Put the supplied CD-ROM into your CD-ROM
drive.
4 Double-click the Start Here OSX icon to install
the printer and scanner drivers. If the language
screen appears, choose your language.
5 Click MFL-Pro Suite to install.
6 Follow the on-screen instructions, and restart
your Macintosh
®
.
7 Lift the scanner cover to its open position.
8 After the DeviceSelector window appears,
connect the network interface cable to your
Macintosh
®
and then to the machine.
Note
The DeviceSelector window will not appear if you
have connected a USB interface cable to the
machine before restarting your Macintosh
®
or if
you are overwriting a previously installed version
of the Brother Software. If you encounter this
problem continue but skip 13 through 16. You
should choose your Brother machine from the
Model pop-up menu in the main screen of
ControlCenter2. For details, see Chapter 10 in the
Software User's Guide on the CD-ROM.
9 Connect the network cable to the LAN socket
marked with a symbol. You will find the
LAN socket above and to the left of the ink
cartridge slots, as shown below.
10 Carefully guide the network cable to the trench
as shown below, following the trench around
and toward the back of the machine.
Then, connect the cable to your network.
To Next Page
Loading...
Need help?
General
