1.3.201.3.20 Print test Print test pattern pattern (function code: (function code: 71)71)
<Function><Function>
This function is used to print a test pattern to check whether the developer roller or exposureThis function is used to print a test pattern to check whether the developer roller or exposure
drum is dirty or damaged.drum is dirty or damaged.
<Operating Procedure><Operating Procedure>
DCP-15** series, MFC-18** seriesDCP-15** series, MFC-18** series
(1(1)) NuNumemeriric kec key pay pad mod modedelsls
Press the [7] and [1] buttons in this order in the initial state of maintenance mode.Press the [7] and [1] buttons in this order in the initial state of maintenance mode.
Non-numeric key pad modelsNon-numeric key pad models
PrPresess ths the [e [ ] or ] or [[ ] bu] butttton ton to dio dispsplalay “My “MAIAINTENTENANANCNCE 71E 71” on ” on ththe LCe LCD anD and prd presess ths thee
[OK] button.[OK] button.
(2)(2) “PRINTI“PRINTING” is disNG” is displayed oplayed on the LCD, ann the LCD, and the 2D3S pd the 2D3S pattern is pattern is printed on a srinted on a single siingle side ofde of
the paper.the paper.
When printing is completed, “2D3S K” is displayed on the LCD.When printing is completed, “2D3S K” is displayed on the LCD.
(3)(3) TTo print the 2o print the 2D3S pattD3S pattern agaiern again, press thn, press the [Ste [Start] buttart] button.on.
(4)(4) When the [SWhen the [Stop/Exitop/Exit] button it] button is presses pressed, the machd, the machine returine returns to the inins to the initial sttial state ofate of
maintenance mode.maintenance mode.
Note:Note:
•• If printing faiIf printing fails, printils, printing is stopped and one of the errorng is stopped and one of the errors shown in the table bels shown in the table below isow is
displayed. Tdisplayed. To retry printing, refer to the o retry printing, refer to the “Remedy” in the table below to eliminate the“Remedy” in the table below to eliminate the
cause of the error, and press the [Start] button.cause of the error, and press the [Start] button.
To Next Page
Loading...
