Brother DCP-4020C - Attaching the Output Paper Support; Attaching the Paper Tray; Removing the Protective Parts; Setting up the DCP

2
Setting Up the DCP
1
Remove the protective tape.
Do NOT connect the USB cable.
Connecting the USB cable is done
when installing the driver.
1
Pull the scanner cover release lever to open
the scanner cover and lift it to the opening
position.
2
Attach the output paper support to the paper
output slot.
3
Close the output paper support and the
scanner cover.
4
Pull out the extension.
1
Insert the paper tray from above into the
back of the DCP.
1
Removing the Protective
Parts
2
Attaching the Output
Paper Support
Scanner Cover
Scanner Cover
Release Lever
Output Paper
Support
3
Attaching the Paper Tray
Output Paper
Support
Scanner
Cover
Output Paper
Support Extension
Paper Tray
Step 1