Setting Up the Machine
3
3 Connecting the power cord
1 Connect the power cord.
Improper Setup
DO NOT connect the interface cable.
Connecting the interface cable is done during
the software installation process.
Warning
The machine must be fitted with an earthed plug.
Note
The control panel warning LED will stay on until
you have installed the ink cartridges.
4 Choosing your language
1 After connecting the power cord, the LCD
shows:
Select Language
English
Français
Deutsch
Nederlands
Italiano
Press a or b to choose your language and
press OK.
2 Choose Yes or No and press OK.
English
Yes
No
3 If your language is chosen, press OK.
5 Installing the ink cartridges
Warning
If ink gets in your eyes, wash them out with water
at once, and if irritation occurs consult a doctor.
1 The LCD shows:
No Cartridge
Black
Yellow
Cyan
Magenta
Note
Make sure that the power is turned on.
2
3
To Next Page
Loading...
Need help?
General
