Brother DCP-8070D - How to Set a New Default for the Duplex Scan Mode (for Scan to E-Mail (E-Mail Server) Only); Maximum ADF Output Tray Capacity (DCP-8070 D, MFC-8370 DN and MFC-8380 DN)

Network Scanning
216
11
How to set a new default for the Duplex Scan mode
(For Scan to E-mail (E-mail server) only) 11
You can set your own default setting for the Duplex Scan mode. You can choose from two types of layout,
long edge or short edge.
a Press Menu, 1.
b Press a or b to choose Document Scan. Press OK.
c Press a or b to choose Duplex Scan. Press OK.
d Press a or b to choose Long edge or Sh ort edge. Press OK.
e Press Stop/Exit.
Maximum ADF output tray capacity
(DCP-8070D, MFC-8370DN and MFC-8380DN) 11
If the maximum capacity of the output tray is reached during use, the machine will stop scanning and the LCD
will show 20 Sheet Limit.
Do one of the following:
 To send the pages scanned so far to a server, press 1.Se nd.
 To delete the scanned pages, press 2.Delete.
If you send the pages already scanned and want to send the remaining pages to a server, remove the
scanned sheets from the ADF output tray and press Start.