Troubleshooting
45
B
f
Move the print head (if necessary) to take
out any paper remaining in this area.
Make sure that jammed paper is not left
in the corners of the machine (1) and (2).
• DO NOT touch the encoder strip (1).
Doing this may cause damage to the
machine.
• If the print head is in the right corner as
shown in the illustration (2), you cannot
move it. Re-connect the power cord. Hold
down Stop/Exit until the print head moves
to the center. Then unplug the machine
from the power source and take out the
paper.
• If the paper is jammed under the print
head, unplug the machine from the power
source, and then move the print head to
take out the paper.
Hold the concave areas with the triangle
marks shown in the illustration (3) to move
the print head.
• If ink gets on your skin or clothing,
immediately wash it off with soap or
detergent.
3
2
To Next Page
Loading...
