Brother DCP-J100

58
Machine Information B
Checking the serial number B
You can see the machine’s serial number on
the LCD.
a Press Menu.
b DCP-J100:
Press a or b to choose
4.Machine Info.
Press OK.
DCP-J105:
Press a or b to choose
5.Machine Info.
Press OK.
c Press a or b to choose 1.Serial No.
Press OK.
Your machine’s serial number will
appear on the LCD.
d Press Stop/Exit.
Checking the firmware
version B
You can see the machine’s firmware version
on the LCD.
a Press Menu.
b DCP-J100:
Press a or b to choose
4.Machine Info.
Press OK.
DCP-J105:
Press a or b to choose
5.Machine Info.
Press OK.
c Press a or b to choose 2.Version.
Press OK.
Your machine’s firmware version will
appear on the LCD.
d Press Stop/Exit.
Reset functions B
The following reset functions are available:
1 Machine Reset
You can reset the machine’s settings,
such as the Date and Time.
2 Network (DCP-J105)
You can reset the print server back to its
default factory settings. Network Reset
will affect the password and IP address
information.
3 All Settings
You can restore all settings to the factory
setting.
Brother strongly recommends performing
this procedure before handing over or
disposing of the machine.
How to reset the machine B
a Press Menu.
b Press a or b to choose
0.Initial Setup.
Press OK.
c Press a or b to choose 4.Reset.
Press OK.
d DCP-J100:
Press a or b to choose the type of reset,
1.Machine Reset or
2.All Settings.
Press OK.
DCP-J105:
Press a or b to choose the type of reset,
1.Machine Reset, 2.Network or
3.All Settings.
Press OK.
e Press a to choose a Reset.
f Press a to confirm.