HE-800A
4. INSTALLATION
26
-
. Installing the belt cover
1. Install the belt cover D plate (2) to belt cover D (1).
2. Provisionally install belt cover D (1) to the table with the two screws (3).
3. Install the two rubber caps (4) to the belt cover (5).
4. Place the belt cover (5) onto the arm, and then install it with the three screws (6).
5. Move belt cover D (1) to adjust it so that it is in the position shown below, and then tighten the two screws (3).
x Set the clearance between the belt cover (5) and the belt cover D plate (2) to 1.5 mm. <Fig. A>
x Install so that the clearances between the belt cover (5) and belt cover D (1) are the same at both the left and right.
<Fig. B>
-
. Installing the auxiliary table
1. Provisionally install the two table support plates (1) to the auxiliary table (2) with the four bolts (3).
2. Install the auxiliary table (2) to the bed (4) with the two bolts (5).
3. While gently pushing the auxiliary table (2) so that there is no clearance between the bed (4) and the auxiliary table
(2), tighten the four bolts (3).
4098M
Clearances
should be the
same
4099M
Set so that there is
no clearance
To Next Page
Loading...
