Brother HE-800A - When Resuming Sewing in Test Feed Mode or Manual Mode



HE-800A
8. SEWING
68
㧤
-
㧡
. When resuming sewing in test feed mode or manual mode
If the thread breaks during sewing and sewing finishes without the broke thread being detected, you can operate the
sewing machine in test feed mode or manual mode until the needle zigzagging and material feed reach the point where
sewing was interrupted, and then complete the rest of the sewing.
1. Press the SELECT key (1) to change the mode to test feed or manual mode.
2. Move the needle zigzag and feed mechanisms to the point to resume sewing using the operations that apply to
whichever mode being used. (Refer to "6-1. Test feed mode" or "6-2. Manual mode".)
3. Raise the needle bar to its highest position.
Note: If the needle bar is not at its highest position when the next step is carried out, error "E-02" will be displayed.
Turn the machine pulley to raise the needle bar to its highest position before continuing.
4. While pressing the ENTER key (2), press the SELECT key (1).
* The mode will change to automatic mode and "E-00" will be displayed.
Note: When step 4. is carried out, the mode cannot be returned to test feed mode or manual mode.
5. Press the parameter UP key (3) or the parameter DOWN key (4).
* The "E-00" display will be cleared.
6. Depress the treadle to start sewing from the current position.
3967Q