CHAPTER 4 CONTROL PANEL
4–19
6. Press the ▲ or ▼ switch until the exit menu appears on the display.
exit MODE
7. Press the SET switch.
Then the printer automatically returns to the off-line ready state.
INTERFACE MODE
The automatic interface selection has been factory set. If you want to
select a specific interface manually, use the interface mode to set it.
Display Message Interface Mode
I/F=PARALLEL Parallel interface
I/F=RS-232C Serial interface
I/F=USB Universal Serial Bus interface
I/F=OPTION Optional interface for MIO card
I/F=AUTO Auto interface selection
Select the setting menu and enter the sub-setting menu to change the
setting as follows:
■ Automatic Interface Selection
1. When you use the automatic interface selection function, select the
function on the display as follows:
I/F=AUTO
2. When you select this function with the SET switch, the display shows
the next sub-setting menu as follows:
TIME OUT
To Next Page
Loading...
