CHAPTER 4 CONTROL PANEL
4–23
When you enter the setting mode, the display first shows the current
orientation with an asterisk.
ORI=PORTRAIT *
Press the ▲ or ▼ switch until the desired orientation appears on the
display.
Display Message Orientation
ORI=PORTRAIT Portrait
ORI=LANDSCAPE Landscape
Press the SET switch to make the displayed selection effective.
An asterisk appears at the end of the display for a short time. Then the
printer automatically exits from the setting mode to the FORMAT
MODE.
When portrait has been selected, the display may look as follows:
00 READY 001P T1
When landscape has been selected, the display may look as follows:
00 READY 001L T1
To Next Page
Loading...
