49
10
10
Scanning a document 10
There are several ways to scan documents.
You can use the (SCAN) key on the
machine or the scanner drivers on your
computer.
a To use the machine as a scanner, install
a scanner driver. If the machine is on a
Network, configure it with a TCP/IP
address.
Install the scanner drivers on the
Installation CD-ROM. (See the Quick
Setup Guide and Scanning in the
Software User's Guide.)
Configure the machine with a TCP/IP
address if network scanning does not
work. (See Configuring Network
Scanning in the Software User’s
Guide.)
b Load your document. (See How to load
documents on page 22.)
Use the ADF to scan multiple pages
of documents. It feeds each sheet
automatically.
Use the scanner glass to scan a
page of a book or one sheet at a
time.
c Do one of the following:
To scan using the (SCAN)
key, go to Scanning using the scan
key on page 49.
To scan using a scanner driver at
your computer, go to Scanning using
a scanner driver on page 50.
Scanning using the
scan key 10
For more information, see Using the Scan
key in the Software User’s Guide.
a Press the (SCAN) key.
b Choose the scan mode you want.
Scan to:
File
E-mail
OCR
1
Image
FTP
2
1
(Macintosh users)
Presto! PageManager must be downloaded
and installed before use. See Accessing
Brother Support (Macintosh) on page 5 for
further instructions.
2
For MFC-7460DN and MFC-7860DW
c Choose the computer you want to send
the data to.
d Press Start to begin scanning.
How to scan to a computer 10
To Next Page
Loading...
Need help?
General
Weight and Dimensions
