Brother HL-4140CN - Setting by Country (Function Code 74)

5-36
Confidential
1.4.19 Setting by country (Function code 74)
<Function>
This function allows you to customize the printer according to language, function settings, and
worker switch settings.
<Operating procedure>
(1) Press the or button to display “MAINTENANCE 74” on the LCD in the initial state of
the maintenance mode. Then, press the OK button. The present country code is
displayed.
(2) Enter the upper 2 digits of the country code that you want to set.
Press the OK button, and the cursor moves from the first digit to the second digit.
(The first digit cannot be selected.)
Press the or button to enter the second digit and press the OK button, and the
cursor moves to the fourth digit.
(3) Enter the lower 2 digits of the country code that you want to set.
Press the or button to enter the third and fourth digits (The numbers which cannot
be selected are skipped.) and press the Go button.
(4) The new setting is saved, and “PARAMETER INIT” is displayed on the LCD. After the
setting is saved, the printer returns to the initial state of the maintenance mode.
Note:
When you replace the main PCB ASSY and rewrite the firmware forcibly, be sure to carry
out this procedure.
Memo:
- To cancel this operation and return to the printer to the initial state of the maintenance
mode during the above procedure, press the Cancel button.
- If there is a pause of more than one minute, the printer will automatically return to the
initial state of the maintenance mode.