Printing Methods
21
1
Manual duplex printing 1
The BR-Script printer driver for Windows
®
does not support manual duplex printing.
If you are using the Macintosh Printer Driver, see Manual Duplex Printing on page 55.
Manual duplex printing with the Windows
®
printer driver 1
a Choose the following settings from each drop-down list of the printer driver.
Paper Size
You can use all the paper sizes specified for the tray you are using.
Media Type
You can use all the media types that are specified for the tray you are using, except envelopes and
labels which have only one print side.
Paper Source
Duplex / Booklet
Duplex Type in Duplex Settings...
There are four options for each orientation. (See Duplex / Booklet on page 32.)
Binding Offset in Duplex Settings
You can specify the offset for binding. (See Duplex / Booklet on page 32.)
When you are using glossy paper, put only one sheet at a time in the MP tray to avoid a paper jam.
For any other settings, see Driver and Software in Chapter 2.
b Send the print data to the machine. The machine will print all the even-numbered pages on one side of
the paper first. Then, the Windows
®
driver instructs you (with a pop-up message) to remove the printed
even-numbered pages from the output tray and put them back in the paper tray 1 or tray 2 with the side
to be printed on (blank side) face down (when using MP Tray, please put paper with the side to be printed
on [blank side] face up).
Before reinserting the paper, straighten it well, or you may get a paper jam. Very thin or thick paper is not
recommended.
Tray 1 MP Tray Tray 2 (if available)
Duplex (Manual)
To Next Page
Loading...
