2-31
Confidential
Detected irregular power
supply for more than 100
times.
0900 2-36
Detected that supply
power is unstable. (less
than 100 times)
6F00 2-44
The center thermistor of the
fuser unit has not reached
the specified temperature
within the specified time
after it was heated normally
to the certain level.
0502 2-35
The hardware detected a
temperature error through the
center thermistor or the side
thermistor of the fuser unit.
050A 2-35
Some fuser unit errors
occurred at power-ON or upon
recovery from sleep mode.
6901 2-43
After the error was
detected at the fuser unit,
power was turned ON
again and the error is
being checked. (If power is
turned OFF and ON after
error code 6901 occurred,
this code is displayed for
about 15 minutes.)
6902 2-43
After the heat unit was
heated normally, the
center thermistor of the
fuser unit detected a
temperature lower than
the specified value.
0504 2-35
The center thermistor of
the fuser unit detected a
temperature rise greater
than the specified value
within the specified time.
0505 2-35
The center thermistor of
the fuser unit detected a
temperature fall greater
than the specified value
within the specified time.
0506 2-35
LED
Press [Go]
once
Press [Go]
twice
Type of problem
Error
codes
Refer
to:
Toner
Ready
Paper
Drum
Toner
Ready
Paper
Drum
Toner
Ready
Paper
Drum
Toner
Ready
Paper
Drum
Toner
Ready
Paper
Drum
To Next Page
Loading...
Need help?
General