Brother MFC-210C Quick Setup Guide

4
Setting Up the Machine
1
Remove the protective tape.
DO NOT connect the USB cable.
Connecting the USB cable is done
when installing the driver.
1
Connect the curled handset cord to the
handset.
1
Pull the paper tray completely out of the
machine and remove the output paper tray.
2
Press and slide the paper guide to fit the
paper width.
3
Pull out the paper support and unfold the
paper support flap.
4
Fan the stack of paper well to avoid paper
jams and mis-feeds.
5
Gently insert the paper into the paper tray
print side down and top edge first.
Check that the paper is flat in the tray and
below the maximum paper mark.
6
Put the output paper tray back on and push
the paper tray firmly back into the machine.
1
Removing the Protective
Parts
2
Installing the Handset
(MFC-620CN only)
3
Loading Paper
You can load up to 100 sheets of 20 lb
paper.
For more details, see “About paper” in
Chapter 1 of the User’s Guide.
Use the paper support flap for Letter, Legal
and A4 size paper.
■
Make sure the paper side guides touch the
sides of the paper.
■
Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause paper feed problems.
Paper Side Guide
Paper Support
Paper Support Flap
Step 1

Brother MFC-210C Specifications

General

Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
Maximum resolution	1200 x 6000 DPI
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	15 ppm
Faxing	No
Modem speed	14.4 Kbit/s
Copy speed (black, normal quality, A4)	17 cpm
Copy speed (color, normal quality, A4)	11 cpm
Scan speed	4 sec/page
Dimensions (WxDxH)	373 x 453 x 135 mm
Color all-in-one functions	copy, print, scan
Grayscale levels	256
Optical scanning resolution	600 x 2400 DPI
Number of print cartridges	4
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Total input capacity	100 sheets
Total output capacity	25 sheets
Market positioning	Home & office