Brother MFC-465CN - Removing Small Printouts from the Machine

Chapter 2
18
a Press the photo bypass tray release
button with your left thumb and push the
photo bypass tray backward until it
clicks into the photo printing position.
1 Photo Bypass Tray
b Press and slide the paper side
guides (1) and paper length guide (2) to
fit the paper size.
c Put the photo paper into the photo
bypass tray and gently adjust the paper
side guides to the paper.
Make sure the paper side guides touch
the sides of the paper.
Note
• Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause feed problems.
• Always make sure that the paper is not
curled.
d When you have finished printing photos
return the photo bypass tray to the
normal printing position.
Press the photo bypass tray release
button with your left thumb and pull the
photo bypass tray forward until it clicks.
Removing small printouts
from the machine 2
When the machine ejects small paper onto
the output paper tray you may not be able to
reach it. Make sure printing has finished, and
then pull the tray completely out of the
machine.
1
1
2