Brother MFC-490CW - Beeper Volume; Speaker Volume

Chapter 3
26
Beeper Volume 3
When the beeper is on, the machine will beep
when you press a key, make a mistake or
after you send or receive a fax.
You can choose a range of volume levels,
from High to Off.
a Press Menu.
b Press a or b to choose
General Setup.
Press OK.
c Press a or b to choose Volume.
Press OK.
d Press a or b to choose Beeper.
e Press d or c to choose Low, Med, High
or Off.
Press OK.
f Press Stop/Exit.
Speaker Volume 3
You can choose a range of speaker volume
levels, from High to Off.
a Press Menu.
b Press a or b to choose
General Setup.
Press OK.
c Press a or b to choose Volume.
Press OK.
d Press a or b to choose Speaker.
e Press d or c to choose Low, Med, High
or Off.
Press OK.
f Press Stop/Exit.
You can also adjust the speaker volume by
pressing Hook.
a Press Hook.
b Press a and d or c .
This setting will stay until you change it
again.
c Press Hook.