INTRODUCTION 1 - 15
How to load paper, envelopes and post cards
To load paper or other media
1
Pull the paper tray completely out of the MFC and remove the
output paper tray.
2
Press and slide the paper side guide to fit the paper width.
3
Pull out the paper support and unfold the paper support flap.
■
For Tray#2, see To load paper in the paper tray#2
(MFC-5840CN only) on page 1-17.
■
(MFC-5840CN only)
If you are using
Auto Select
, after refilling the paper tray
you should open and close the scanner cover to reset it.
Use the paper support flap for Letter, Legal and A4.
Paper Side Guide
Paper Support
Paper Support Flap
To Next Page
Loading...
Need help?
General
