Brother MFC-7840W - Macintosh; For USB Interface Cable Users; 10.2.4 or Greater; For Mac os X 10.2.4 or Greater

Installing the Driver & Software
29
Macintosh
®
Macintosh
®
USB
4 For USB Interface Cable Users
For Mac OS
®
X 10.2.4 or greater
Important
Make sure that you have finished the
instructions from step 1 Setting Up the
Machine on pages 4 through 11.
Note
For Mac OS
®
X 10.2.0 to 10.2.3 users, upgrade to
Mac OS
®
X 10.2.4 or greater. (For the latest
information for Mac OS
®
X, visit
http://solutions.brother.com/
)
1 Plug the AC power cord into an AC outlet. Turn
the power switch on.
2 Connect the USB interface cable to your
computer, and then connect it to the machine.
Improper Setup
DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your computer.
3 Turn on your Macintosh
®
.
4 Put the supplied CD-ROM into your CD-ROM
drive.
5 Double-click the Start Here OSX icon to install.
Follow the on-screen instructions.
Note
Please see the Software User’s Guide on the CD-
ROM if you want to install the PS driver.
6 Choose Local Connection (USB), and then
click Next. The installation will continue.
Note
Please wait, it will take a few seconds for the
software to install. After the installation, click
Restart to finish installing the software.