Brother MFC-8860DN - For USB Interface Cable Users; For Mac os X 10.2.4 or Greater

24
Make sure that you have finished the instructions from Step 1 “Setting Up
the machine” on pages 4 - 11.
1 Switch off the machine and disconnect the
machine from the power socket (and from
the Macintosh
®
, if you have already
connected an interface cable).
2 Turn on your Macintosh
®
.
3 Insert the supplied CD-ROM for Macintosh
®
into your CD-ROM drive.
4 Double-click the MFL-Pro Suite.
5 Follow the on-screen instructions, and
restart your Macintosh
®
.
6 After the Brother DeviceSelector window
appears, connect the USB interface cable to
your Macintosh
®
and then to the machine.
For USB Interface Cable Users
For Mac OS
®
X 10.2.4 or greater
For Mac OS
®
X 10.2.0 to 10.2.3 users,
upgrade to Mac OS
®
X 10.2.4 or greater. (For
the latest information for Mac OS
®
X, visit
http://solutions.brother.com)
The Brother DeviceSelector window will not
appear if you have also connected a USB
interface cable to the machine before
restarting your Macintosh
®
or if you are
overwriting a previously installed version of
the Brother software. If you encounter this
problem continue with the installation but skip
Step 9. You should choose your Brother
machine from the Model pull-down list in the
main screen of ControlCenter2. (For details,
see the Software User’s Guide on CD-ROM.)
Step 2
Installing the Drivers & Software