Installing the Driver & Software
37
Macintosh
®
Macintosh
®
Wired
Network
For Wired Network Interface Users
For Mac OS
®
X 10.2.4 or greater
Important
Make sure that you have finished the
instructions from step 1 Setting Up the
Machine on page 4 to 11.
1 Switch off the machine, then disconnect the
machine from the power socket and from the
network.
2 Turn on your Macintosh
®
.
3 Put the supplied CD-ROM into your CD-ROM
drive.
4 Double-click the Start Here OSX icon to install
the drivers and MFL-Pro Suite. If the language
screen appears, choose your language.
5 Click MFL-Pro Suite to install.
6 Choose Wired Network Connection, and
then click Next. Follow the on-screen
instructions, and restart your Macintosh
®
.
7 After the DeviceSelector window appears,
connect the network interface cable to your
Macintosh
®
and then to the machine.
Note
The DeviceSelector window will not appear if you
have also connected a USB interface cable to the
machine before restarting your Macintosh
®
or if
you are overwriting a previously installed version
of the Brother Software. If you encounter this
problem continue but skip steps 9 to 12. After the
software installation is completed you should
choose your Brother machine from the Model pull-
down list in the main screen of ControlCenter2.
For details, see Chapter 10 in the Software User’s
Guide on the CD-ROM.
To Next Page
Loading...
