Brother MFC-J200 - For Wireless Network Users; Before You Begin

15
For Wireless Network Users
Wireless Network
For wireless network interface users
13
Before you begin
14
Choose your wireless setup method
The following instructions will offer three methods for setting up your Brother machine on a wireless network. If
you began the wireless setup from step 7 on page 6, go to method b or c. For all other users, choose the method
you prefer for your environment.
Method a is the recommended way to connect (Windows
®
or Macintosh).
NOTE
If you have previously configured the wireless settings of the machine, you must reset the network settings
before you can configure the wireless settings again.
On your machine, press Menu.
Press 5 to choose 5.Network.
Press 0 to choose 0.Network Reset.
Press 1 twice to accept the change.
NOTE
To set up your machine in Ad-hoc mode (connected to a wireless-capable computer without an access
point/router), see instructions in the Software and Network User’s Guide on the CD-ROM.
To view the Software and Network User’s Guide:
1 Turn on your computer. Insert the CD-ROM into your CD-ROM drive.
For Windows
®
:
2 Choose your model and the language. The CD-ROM top menu will appear.
3Click User’s Guides, and then click PDF/HTML documents.
4Click Software and Network User’s Guide.
For Macintosh:
2 Double-click User’s Guides. Choose your model and the language.
3Click User’s Guides, and then click Software and Network User’s Guide.
a Setup using the CD-ROM (Windows
®
and Macintosh)
• We recommend using a computer wirelessly connected to your network for this method.
• A USB cable might be needed in some cases.
Now go to
page 17