5
d Fan the stack of paper well to avoid paper jams
and misfeeds.
e Gently put the paper into the paper tray print
side down and top edge first. Check that the
paper is flat in the tray.
f Gently adjust the paper width guides to the
paper with both hands. Make sure that the
paper width guides touch the edges of the
paper.
g Close the output paper tray cover.
h Slowly push the paper tray completely into the
machine.
i While holding the paper tray in place, pull out
the paper support until it clicks, and then unfold
the paper support flap.
5
Check the print quality
a When the preparation process has finished, the
LCD shows this message
Set Paper and
q
Press Start
Press Colour Start.
b Check the quality of the four colour blocks on
the sheet. (black/yellow/cyan/magenta)
c If all lines are clear and visible, press 1 (Yes) to
finish the quality check and go to the next step.
If lines are missing, press 2 (No) and follow the
steps on the LCD.
Always make sure that the paper is not curled or
wrinkled.
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
To Next Page
Loading...
