Brother MFC-J200 - General information; Using the documentation; Symbols and conventions used in the documentation; Accessing Brother Utilities (Windows 8)

4
f Gently push the back of the ink cartridge
marked “PUSH” until the cartridge lever lifts.
After all the ink cartridges are installed, close
the ink cartridge cover.
4
Load plain A4 paper
a Pull the paper tray completely out of the
machine.
b Open the output paper tray cover.
c Gently press and slide the paper width
guides a and then the paper length guide b to
fit the paper size.
Make sure that the triangular marks c on the
paper width guides a and paper length
guide b line up with the mark for the paper size
you are using.
IMPORTANT
After initial installation of the ink cartridges, the
machine will start cleaning the ink tube system.
This cleaning process will last approximately four
minutes.
DO NOT unplug the machine from the power
outlet or attempt to stop the cleaning process.
Interruption of cleaning process may cause
undesired print quality problems.
IMPORTANT
• DO NOT take out ink cartridges if you do not
need to replace them. If you do so, it may
reduce the ink quantity and the machine will not
know the quantity of ink left in the cartridge.
• DO NOT repeatedly insert and remove the
cartridges. If you do so, ink may seep out of the
cartridge.
• Once you open an ink cartridge, install it in the
machine and use it up within six months of
installation. Use unopened ink cartridges by
the expiration date written on the cartridge
package.
• DO NOT dismantle or tamper with the ink
cartridge, this can cause the ink to leak out of
the cartridge.
• Brother multifunction machines are designed to
work with ink of a particular specification and
will work to a level of optimum performance
when used with genuine Brother branded ink
cartridges. Brother cannot guarantee this
optimum performance if ink or ink cartridges of
other specifications are used. Brother does not
therefore recommend the use of cartridges
other than genuine Brother branded cartridges
with this machine or the refilling of empty
cartridges with ink from other sources. If
damage is caused to the print head or other
parts of this machine as a result of using
incompatible products with this machine, any
repairs required as a result may not be covered
by the warranty.
1
2
3
3